Tektronix AD007 - Manual (Page 50)

Operating Basics
36 AD007 User Manual
Network Setup
At power on, the AD007 automatically configures its entire Network
Setup from a Dynamic Host Configuration Protocol (DHCP) or Boot
Protocol (BOOTP) server. If you do not have a server that supports
DHCP/BOOTP, you may have to access the Network Setup page to
examine and change one or more of the following network settings.
Host Configuration
If your server does not support the DHCP/BOOTP protocols, do
these steps to bypass the protocols:
1. If you have access to the web pages, go the the Network Setup
page and select DHCP Off.
2. If you do not have access to the web pages, momentarily press
the reset button during power on to bypass the DHCP/BOOTP
request and reset to the last configuration. (For the location of the
reset button, see Figure 11 on page 48.)
Networking
To allow the adapter to talk to other hosts on the local network, enter
the appropriate IP numbers for Adapter IP Address and Subnet Mask.
To allow the adapter to talk to hosts on other networks, enter the
appropriate IP number for Router Address.