Technicolor - Thomson VMD 6 - Manual (Page 47)

46
EN
PL
AY
OFF
T
P O
US C
H OP
S
Y
TA T
R
O
T /
T
S A
T
P
O
E
P
R
4
E
4
C
4
Power Switch
Rewind Button (2)
Fast-Forward
Button (3)
Lock Button
Dubbing Images Stored In A
MultiMediaCard To A Tape
Images can be dubbed from a MultiMediaCard to a tape.
1 Load a MultiMediaCard (
੬
pg. 11) and cassette
(
੬
pg. 10).
2 To locate the point where you wish to dub a still
image, play back the tape. Stop playback at the
desired point.
3
2
Set the VIDEO/DSC Switch to “ ”, then set the
Power Switch to “ ” while pressing down the
Lock Button located on the switch.
4
3
To select a still image to be dubbed, perform Index
Playback (
੬
pg. 35) or press 2 or 3 to select the
image you wish.
5 To engage Dub-Standby, press the Recording Start/
Stop Button. The message “TO COPY TO TAPE PUSH
START/STOP” appears.
6 While the message is being displayed, press the
Recording Start/Stop Button. The selected still image
is recorded on the tape for approx. 5 seconds.
•The
indicator disappears when dubbing is
complete.
NOTE:
If the Recording Start/Stop Button is pressed in step 5 when
the tape’s erase protection tab is set to “SAVE”, the
message “COPYING FAILED” is displayed.
Display
DUBBING (cont.)
Recording
Start/Stop Button
VIDEO/DSC Switch (Open the
LCD monitor to access this switch.)
VMD6 EN(40/80) 28/08/00, 16:07 46