Tekxon Technology K3 - Manual (Page 21)

19
5 Advanced operation
5.1 Using the flash
If there is not enough available light for your photo, the built-in flash can provide the additional
light required.
1 Switch the camera on and select the photo mode (single shot or self-
timer mode).
2 Press the right button once or repeatedly to set one of three flash
modes. The flash mode changes from “Auto” to “Always on” to “Off”
each time you press the button. The corresponding status symbol for
the flash mode is shown in the upper left corner of the LCD.
The flash is activated automatically when the light level is too low if
the flash is set to “Auto”. When “Always on” is set the flash is used
for every shot. When “Off” is selected, the flash is deactivated.
The flash only works in single shot mode and self-timer mode.
It does not work in burst and video mode.
Please note that using the flash increases battery consumption.
5.2 Using direct access buttons
Selecting photography mode directly
In photography mode, you can access the “Single” , “SelfTimer” and “Sequence”
modes by pressing the left button repeatedly. The corresponding symbol is displayed at
the top left of the LCD.
Selecting the resolution directly
In photography mode, the OK button can be used to select the resolution progressively. The
current resolution is displayed at the top left of the LCD.
Accessing the flash mode directly
You can set the flash to “Auto” , “Always on” or “Off” by
pressing the right button in single shot and self-timer modes.
The corresponding symbol is displayed on the LCD.