TechniSat ST 6002 S - Manual (Page 15)

TechniSat ST 6002 S
Return the cursor to "Sat" and use the buttons to select
the satellite which you wish to store next. Repeat the same
procedure as described above. All satellites can be stored by
this method.
NOTE: Not all satellite channels are transmitting continuous-
ly. Additionally, it may also be necessary to alter the "Skew"
values depending on the polariser type (refer to later section
on "Changing Channel Parameters").
Programming of Future Satellites
1. If you wish to store a new satellite which is not already pre-
set, you can choose an already stored channel with a frequency
which is nearest to the frequency of a channel on the new
satellite. The polarisation and LNB type must also be taken
into account. After entering the required data, move the cur-
sor to “Position” and move the dish using the
keys until
you receive the desired channel.
2. Now move the cursor to “Sat” and select a satellite which
is not already stored (Spare 1-32). The channel selected pre-
viously can no longer be viewed. Move the cursor to “Pos” and
press
followed by ENTER on RCU. The satellite is now sto-
red. To store the channels on this satellite it is necessary to
follow the procedures set out in the section on “Channel data".
16
E N T E R