TechniSat ST 6002 S - Manual (Page 24)

TechniSat ST 6002 S
7.2. Direct Operation
You can select the desired channel via the Key Pad. Simply select the channel number (see the pro-
gram tables). The channel number will appear on the receiver display and also on the screen.
When you choose a 3-fig. channel number the receiver goes directly to the desired channel. If a 1-
or 2-fig. number is selected, the receiver waits initially for a further number. If this is not selected after
a few seconds it will directly go to the 1- or 2-fig. channel.
Example: Input 004 the receiver goes directly to channel 4 and the screen will show the
satellite programme number and programme name
Input 04 the third place of the screen display flashes for about 3 seconds and
then goes to programme 4
When the desired channel is from another satellite, the receiver will automatically turn to the new posi-
tion. If this satellite has not been stored, a message will appear.
In addition to this there is the possibility to use the keys to select the previous or next channel.
If in doing this the limits of the satellite are reached, the following message appears on the screen:
This message stays on the screen for a few seconds. The channel will only be selected if you press
ENTER and the dish will then move to the desired satellite.
With the keys on the RCU you can adjust the volume.
Every time you press ENTER, the name of the satellite, channel number and time will appear on the
screen.
With the keys on the receiver you can choose other satellites and with the keys .on the
receiver you can change channels. In this way you can operate the receiver without the RCU.
25
nächster Satellit
XXXXX
drücken Sie:
ENTER
E N T E R