Tascam DP-02 - Manual (Page 23)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM DP-02/DP-02CF

1 – Starting out with your DP-02/DP-02CF
You can view the title, working partition, and amount of
time left for recording from the “home screen”.
From the home screen, press and hold the SHIFT key and
press the SONG key.
The display shows:
the current partition (
PARTITION
), song title (
SONG
) and
amount of time left on the partition for recording ( REMAIN )
in minutes.
Pressing the NO/EXIT key returns to the home screen.
Additional song operations
Further song operations are described in “Advanced song
management” on page 41.
Song information
Assigning inputs
When we talk about “assigning” inputs, we are talking
about routing the signals from the two inputs to the tracks.
You can record on up to two tracks at a time. This means
that the same input can be assigned to two tracks at the
same time (but you can’t then use the other input) or the
two inputs can be assigned to different tracks. You can’t
assign both inputs to the same track at the same time.
ASSIGN keys
Eight REC keys
1. Press and hold the ASSIGN key corresponding
to the input signal you are assigning ( A or B ).
T I P
Press and hold SHIFT and either of the ASSIGN keys
(A or B) to turn the inputs on or off as shown by the
indicator. You may want to turn off unused inputs to
reduce noise.
2. While holding down the ASSIGN key, press the
REC key of the track to which you are assigning the
input. The REC key flashes rapidly.
If you want to assign the input to another track, you must
first clear the current assignment (see below), and then
re-assign the input.
Note that the REC key of the first track to which you
assigned the input flashes when you hold down the
ASSIGN key.
Clearing an assignment
Hold down the ASSIGN key to check current assignments,
then while holding the ASSIGN key, clear current assign-
ments by pressing a flashing REC key (which then stops
flashing).
ª