Tascam DP-02 - Manual (Page 62)

IMPORTANT SAFETY PRECAUTIONS

TASCAM DP-02/DP-02CF
4 – DP-02 Appendix
Vocal settings (Vocal)
De-Esser Removes sibilance (ess sounds)
Chorist Choir sound using detuning
Emphasis Adds emphasis to vocals to make them stand out
Shout For loud distorted vocals
Moody Moody feeling for quieter smooth vocal lines
Response Echo vocal setting
Proclaim “Echo plus” — a distinctive sound
Quiverin A quavering voice with vibrato
Duet For two (male and female) singers and harmony groups
Lo-Fi Imitates low-fidelity equipment (high and low treated specially)
Megaphon For “megaphone”-type sound
Screamin Screaming sound using flanger
Panning A panned stereo vocal sound
Drum settings (Drum)
These sound good with rhythm machines, etc.
Groove A groove setting with flanger
Stepping Stepping beat — delay with a small amount of feedback
TrnAroun Stereo “bouncing” setting
GetSpace Drum reverb
CsBottom Classic “bass heavy” sound
Trem.Pad Another stereo bounce setting
PerfrmEQ Echo and pan
Lo-Fi Low fidelity for drums
Reverb Reverberation only
Comp. Compressor only
Vibrato A vibrato effect
Filter A creative low-pass filter effect
The reverb effect is available as an alternative to the exter-
nal
SEND / RETURN loop with an external effect processor
(see “Effect processor” on page 13). You cannot use both at
the same time.
T I P
“Reverb” is short for “reverberation” the sound produced
by many short echoes off the walls of rooms, etc.
Turning the reverb on and off
Press and hold the SHIFT key and press the REVERB key
to turn the reverb on (the indicator lights) and off (the indi-
cator is unlit).
Using the reverb
When the reverb is on, the mixer EFFECT SEND controls
and the EFFECT RETURN control affect the amount of
signal sent to the internal reverb from the tracks, and
returned from the internal reverb unit to the stereo mix.
When the reverb is turned off, the mixer EFFECT SEND
controls and the EFFECT RETURN control affect the
amount of signal sent to the SEND jack from the tracks,
and returned to the stereo mix via the RETURN jacks.
ª
ª
Setting the reverb type
Bring up the reverb screen by pressing the REVERB key:
Turn the DATA dial to select one of the different “flavors”
of reverb: Hall, Room, Live or Studio. Each of these
settings has a different quality and character.
Setting the reverb time
With the reverb screen displayed, use the cursor ( § / ¶ )
keys to highlight the value below
TIME
.
Simply turn the DATA dial to change the time the reverb
sound takes to die away, from 0.1 seconds to 5.0 seconds in
0.1 second steps.
ª
ª
Reverb