Telular Phonecell SX5T CDMA2000 - Manual (Page 40)

Phonecell ® SX5T CDMA2000 36 User Manual
Conformance Statements
The SX5T 800/1900 MHz models are in conformance with all applicable FCC requirements.
FCC Part 15/Part 22/Part 24 Class B Compliance
This Phonecell ® SX5T model has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15, Part 22 and Part 24 of the FCC rules. Changes or modifications not
expressly approved by Telular Corporation will void your authority to operate the equipment per FCC
part 15 paragraph 15.21.These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the antenna.
• Increase the separation between the equipment and the terminal.
• Connect the equipment into an outlet on a circuit different from that to which the terminal is
connected.
• Consult your Authorized Telular Distributor or an experienced radio/TV technician for help.
Safety Information
The Phonecell ® SX5T functions as both a radio transmitter and receiver. When it is ON, the SX5T
receives and sends out radio frequency (RF) energy. The SX5T CDMA unit operates in the
frequency ranges of 824 MHz to 894 MHz and / or 1850 MHz to 1910 MHz. When you use the SX5T,
the cellular system handling your call controls the power level at which the unit transmits.
Exposure to RF (Radio Frequency) Energy
In 1991, the Institute of Electrical and Electronics Engineers (IEEE), and in 1992, the American
National Standards Institute (ANSI), updated the 1982 ANSI Standard for safety levels with respect
to human exposure to RF energy. After reviewing the available body of research, more than 120
scientists, engineers and physicians from universities, government health agencies and industry
developed this updated Standard. In March, 1993, the U.S. Federal Communications Commission
(FCC) proposed the adoption of this updated Standard.
The design of the Telular Phonecell ® SX5T complies with this updated Standard. Of course, if you
want to limit RF exposure even further than the updated ANSI Standard, you may choose to control
the duration of your calls and operate your phone in the most power-efficient manner.
Safe Operation Requirement
The Phonecell ® SX5T must be either wall mounted or desk mounted and should not be operated
when any person is within 20 cm (8 inches) of the antenna.
Temperature Environment
Operating Temperature: From -10°C to +50°C ; Up to 95% relative humidity (non-condensing).
Storage Temperature: From -40°C to +60°C; Up to 95% relative humidity (non-condensing).
Antenna Care and Replacement
Do not use the Phonecell ® SX5T with a damaged antenna. If a damaged antenna comes into
contact with the skin, a minor burn may result. Replace a damaged antenna immediately. Use only a
Telular-approved antenna. Unauthorized antennas, modifications, or attachments could damage
the Phonecell
® SX5T.