Telular Phonecell SX5T CDMA2000 - Manual (Page 5)

Phonecell ® SX5T CDMA2000 1 User Manual
Setup
RUIM Card Installation (RUIM Model Only)
Consult your service provider to determine if your unit requires the use of a RUIM (Removable User
Identity Module) card. If it is a RUIM model, your SX5T will only be able to make emergency calls until
you install a RUIM card. It will not receive calls or allow non-emergency outgoing calls without the
RUIM card installed.
1. Remove the power supply if it has already been connected. (The power supply must be
removed whenever a RUIM Card is removed or installed.) If your unit has emergency batteries
installed, make sure the AC/Batter Switch is in the AC Power position (see “Battery Operation”
on page 3).
2. Remove the RUIM compartment cover - see Figure 1.
3. Open the RUIM compartment holder.
4. Line up the RUIM card with the arrow on the RUIM card holder - see Figure 2.
5. Gently insert the RUIM card in the slot of the RUIM card holder.
6. Close the RUIM card holder.
7. Reattach the RUIM compartment cover, closing it with the separate cover screw provided.
RUIM
Compartment
Cover
RUIM Card
Holder
RUIM Card
Cover Screw
Figure 2 - Install the RUIM Card. Figure 1 - RUIM Compartment.
Note:
Do not force the RUIM card holder shut. Make sure the RUIM card is aligned properly with the
directional arrow on the holder.