Toshiba 32A3500T - Manual (Page 28)

28
Connecting your TV
Selecting the PC/HDMI1 audio mode
You can select PC audio (- page 29) or HDMI1
audio when using this function.
1
Press
M, then press I or i to display the SET
UP menu.
AV connection
Manual tuning OK
OK
Auto tuning OK
Language
SET UP
English
OK Picture position
MENU Back Watch TV EXIT
2
Press u or U to select AV connection, then
press
Q to display the AV connection menu.
MENU Back Watch TV EXIT
PC/HDMI1 audio
HDMI1 audio
AV connection
PC
Digital
3
Press u or U to select PC/HDMI1 audio, then
press I or i to select PC or HDMI1.
Setting the HDMI1 audio mode
You can select sound of an HDMI or DVI device
connected to the HDMI1 input terminals
(- page 27) from three modes:
Auto, Digital or Analog.
Note:
This function is available only when the
PC/HDMI1 audio mode is set to HDMI1.
1
Press
M, then press I or i to display the SET
UP menu.
AV connection
Manual tuning OK
OK
Auto tuning OK
Language
SET UP
English
OK Picture position
MENU Back Watch TV EXIT
2
Press u or U to select AV connection, then
press
Q to display the AV connection menu.
MENU Back Watch TV EXIT
PC/HDMI1 audio
HDMI1 audio
AV connection
HDMI1
Auto
3
Press u or U to select HDMI1 audio, then
press I or i to select Auto, Digital or Analog.
When the sound is not audible:
If no sound comes out while receiving HDMI
signal, the sound may be audible when using this
function set to off.
1
From the HDMI1 audio item in the AV
connection, press and hold
Q until the Lip
Sync Latency menu appears on the screen.
Lip Sync Latency On
2
Press I or i to select Off.
3
Press
J on the remote control or ! on the
TV right side panel to switch to the standby
mode.
4
Press
J on the remote control or ! on the
TV right side panel again to switch the power
on.
Note:
Depending on some external equipment, the
sound may be audible by turning it off and on
again.