Topcom WEBTALKER 6000 - Manual (Page 9)

R How to install the handset
1) Push the top of the battery compartment cover on the back of the handset inwards and downwards.
2) Insert the two batteries provided with the handset, making sure that their plus and minus ends are facing
the same way as shown in the illustrations on the sides of the battery compartment.
3) Slide the battery compartment cover shut.
4) Affix the belt clip as illustrated.
5) Connect the power adapter of the charging cradle to an active power outlet.
6) Place the handset in the charging cradle to charge the batteries.
7) Wait for 10 minutes and the batteries will be ready for first-time start-up.
NOTES:
• After completion of the full installation procedure we recommend that you charge the batteries fully
before first use. This takes approximately 6 hours.
• Normally, you need to be within 50 m of the base station to connect successfully.
1 )
R
100-240V
2 ) 3 )
4 ) 5 )
6 ) 7 )
10 min.
9 I N S TA L L AT I O N A N D B A S I C F U N C T I O N S
ENGLISH
1
SECTION