TechniSat Car Radio - Manual (Page 10)

If you have entered a wrong code the device will switch off after a few
seconds. The message “SEC ERR“ is now shown on the display. Afterwards the
code has to be re-entered.
- After approx. 40 seconds the TechniSat WERRA 1 has accepted the
modification and signalizes this with a tone. During this time it is not
possible to make any further modification of the security code.
The display shows “SEC ON“ or “SEC OFF“ (depending on the function being
switched on or off) for a few seconds.
3.1.8 Adjusting the number of connected loudspeakers
The TechniSat WERRA 1 can be operated with two or four loudspeakers. To
adapt the device to the number of loudspeakers proceed as follows:
- Switch on the car radio (see also 3.1.1).
- Push the button for approx. 4 seconds until the message “2 SPKRS“ or
“4 SPKRS“ is shown on the display.
- By pushing the button you can switch between 2 and 4
loudspeakers.
The setting will be stored automatically after a few seconds. The device then
returns to normal operation.
Only if four loudspeakers are connected the FADER function will be activated.
BAND
SEL
Switching on/off the security code:
Proceed as follows:
Turn on the radio (see also 3.1.1).
- Push the button for approx. 4 seconds.
The display shows “SPKRS“.
- Push the button once.
The displays now shows “SEC ON“ or “SEC OFF“.
These indications show if the security code function is switched on or
switched off.
- In order to change push the button once.
Now “C*“ is shown on the display.
- Enter the code number of the device by means of the buttons ,
and as described under “Entering the code“.
After the last figure has been stored by pushing the button the letters
“SPKRS“ are displayed again and a few seconds later the device changes to
normal operation.
BAND
BAND >>
<<
BAND
<<
SEL
10
3 Detailed instructions 3 Detailed instructions
Push for approx. 4 sec.
until “SPKRS“ is on display
S
te
p
1
Ste p 3
S t e p 4
Switch on
Push once until
“SEC ON“ or
“SEC OFF“
appears
Push once to
change -
“C-*“ is on
display
Enter the
code;
confirm
every digit
with the
BAND
button
Switch between 2 and 4
loudspeakers; automatic
storage
Ste p 2
Push for approx. 4 sec. until “2 SPKRS“
or “4 SPKRS“ is shown
S
te
p
5
S
te
p
1
Switch on
S t e p 3
Ste p 2
Bed.Anl. Werra1 englisch 09.04.1998 11:53 Uhr Seite 10