TechniSat Car Radio - Manual (Page 12)

Calling up the stations memorized as above:
- Activate the memory positions on which the programmes of the
selected frequency range have been stored by means of a short push
on the button.
- The six programmes stored can be called up by pushing the
buttons -
Automatic station search:
The TechniSat WERRA 1 is equipped with an automatic station search system
which stops on the first station received after starting.The reception range which
has just been selected is searched through.
The searching sensitivity can be switched by the button.
Adjusting the searching sensitivity:
- By a short push on the button you can switch the searching
sensitivity between “local“ (display on device: “LOC“) and “normal“.
When set to “local“ the automatic station search stops only at stations which can
strongly be received. If no station can be found the function will automatically
switch to normal searching sensitivity.
LOC
LOC
6 1
AST
3.2.2 Station search/station memory
The TechniSat WERRA 1 offers four different possibilities to search for the radio
station: manual station search, automatic station search, AST function and
search for the type of programme.
The stations which have been found can then be stored separately for each
band selected under 3.2.1. For each band a maximum of six stations can be
stored.
AST function:
With the AST function you have the possibility to find and to store the six
strongest stations of the FM or the MW band by means of one simple push on
the button. This function can be called up as follows:
- Select the FM or the MW band as described under 3.2.1.
- Push and hold the button for approx. 2 seconds until a signal tone
can be heard. Now the AST function starts to work. During the station
search the message “STORE“ is displayed.
After a few seconds the station search and memory is finished. The stations
which have been found are stored under “AST“ separately for the selected
frequency range. This has no influence on the stations which are stored under
“F1“,“F2“ or “MW“. After completion you can quit the AST range by pushing the
button. BAND
AST
12
3 Detailed instructions 3 Detailed instructions
Quit the AST range
S t e p 2
Push AST for
approx. 2 sec.
until signal can
be heard; “STORE“
is displayed
S
te
p
1
Select the desired programme
S t e p 2
Shortly push AST
S
te
p
1
Shortly push LOC
S
te
p
1
REG
AST AF TP PTY
REG
AST AF TP PTY
Bed.Anl. Werra1 englisch 09.04.1998 11:53 Uhr Seite 12