TechniSat Car Radio - Manual (Page 11)

3.2 Radio unit
The TechniSat WERRA 1 is equipped with a high-quality radio reception unit for
the reception bands FM, MW, SW and LW. The following chapter describes how
to use these bands and the functions which are connected with them.
3.2.1 Adjusting the reception range
With your TechniSat WERRA 1 you are able to switch between three memory
ranges for FM programmes (F1, F2 and AST-FM). Furthermore, you can select
between the reception ranges AST-AM, MW, SW and LW (AM bands). It is
possible to store a maximum of six radio stations in each memory resp.
reception range.
To select the reception range proceed as follows:
Switching between F1 and F2:
- By shortly pushing the button you can switch between the FM
memory ranges F1 and F2.
Switching to AST memory:
- See 3.2.2 “AST function“
BAND
11
3 Detailed instructions 3 Detailed instructions
Short push - switching
between F1 and F2
S t e p 1
Push for approx. 2 sec. -
switching from FM to AM
S t e p 1
Step 1: Push for approx. 2 sec.;
select the AM band;
switch between MW, LW and SW by shortly
pushing this button S t e p 1
Switching between FM and AM band (MW, SW, LW):
- With a longer push (approx. 2 seconds) on the button you can
switch between the FM and the AM band.
Selecting the MW, SW or LW band:
- Switch to the AM band as described under “Switching between FM and
AM band“.
- By shortly pushing the button you can switch between MW, LW
and SW. In the display the selected band is now indicated.
BAND
BAND
Bed.Anl. Werra1 englisch 09.04.1998 11:53 Uhr Seite 11