TechniSat DigiPal 2 - Manual (Page 18)

6.3.6 Dolby Digital (AC3)*
A number of movies are transmitted in the Dolby Digital for-
mat. This is indicated after a programme has been selected
by the Dolby logo
in the information window. If you have
connected a Dolby Digital 5.1 channel amplifier to the system,
you can enjoy movies in 5.1 channel Dolby Digital sound
where available.
To enjoy this feature, you must simply connect the Audio Out
Digital output (see Point 4.5.2) of your DVB receivers with the
digital input of your Dolby Digital 5.1 channel amplifier.
Where a programme is broadcast in Dolby Digital sound, this
will be indicated by the Dolby logo being displayed in the
information window when the programme is selected. If the
function Dolby Digital (AC3) is switched on, these program-
mes will automatically be reproduced in Dolby Digital format.
If the function is not enabled (
off) , Dolby Digital sound can
also be switched on manually. Please refer to Point 7.4.1 of
this operating manual.
6.4 Antenna adjustment
To position the antenna in the optimum direction, the receiver
is equipped with a signal strength indicator.
>
Press the Menu key to display the Main Menu.
> Now use the arrow keys up/down to select the
entry Settings.
> Confirm by pressing OK.
The sub-menu Settings will be displayed.
(Fig. 6-6)
> Now use the arrow keys up/down to mark the
menu line Antenna adjustment.
> Confirm by pressing OK. The menu Antenna
adjustment will be displayed. (Fig. 6-7)
> Now use the arrow keys left/right to enter the
channel with the weakest reception signal.
> Now position the antenna in such a way that both bars
show a maximum position.
red bar
poor reception
yellow bar good reception
green bar excellent reception
7 Operation
7.1 Switching on and off
> You can switch on the digital receiver by pressing the
On/Standby key either on the receiver front panel, or
on the remote control.
18
(Fig. 6-7)
(Fig. 6-6)
* valid only for DigiPal 2
Bedanl DigiPal2_DigitMod T1engl 15.06.2005 16:33 Uhr Seite 18