TechniSat DigiPal 2 - Manual (Page 54)

For daily use
Switching on and off
> Switch on the digital receiver bypressing the
On/Standby key, either on the receiver or on the
remote control.
> Press this key again to switch the receiver off.
> The receiver is now in standby mode, the display on
the receiver shows the time.
Programme selection
Using the programme up/down keys
> Use the programme keys up/down either on the
remote control or on the receiver to move up or down
one programme slot at a time.
Using the numeric keys
> Use the numeric keys to enter the desired programme
number.
For example
1 for programme slot 1
1, then 4 for programme slot 14
2, then 3, then 4 for programme slot 234
When entering programme numbers consisting of several
digits, you have approximately 3 seconds after pressing a key
to complete the entry.
If you wish to enter a number consisting of only one or two
digits, you can speed up the switching procedure by keeping
the key depressed a little longer on the last digit.
Using the programme list:
> Press OK.
> You can now use the arrow keys up/down to mark
the desired programme.
> Press OK to switch to the marked programme.
> Use the arrow keys up/down to move the marker
by one line at a time within the list.
> Use the arrow keys right/left to move the
marker around the list one page at a time.
Volume control
> You can regulate the volume of your digital receiver:
press the key
Volume + to increase the volume, and
Volume - to decrease it.
> Press the key Sound on/off to switch the sound on
or off (mute).
54 2233450003900
Bedanl DigiPal2_DigitMod T1engl 15.06.2005 16:33 Uhr Seite 54