Telenetics V.34-SDC - Manual (Page 87)

Using the AT Automatic Calling Interface 5-1
Using the
AT
A
C
U
Chapter 5
Using the AT Automatic Calling Interface
Contents
Introduction .................................................................................................. 5-2
What is the Attention (AT) Command Set? .................................................. 5-3
What Role Does Communications Software Play? .................................. 5-3
Using AT Commands .................................................................................... 5-3
Entering AT Command Lines ................................................................... 5-3
Autobaud Feature ..................................................................................... 5-5
The Escape Sequence—(+++) ................................................................. 5-5
Non-Configuration AT Commands .......................................................... 5-6
S-Registers ............................................................................................... 5-9