Tunturi E40 User Manual

Page 12

Advertising
background image

12

O

W

N

E

R

’S

M

A

N

U

A

L

MEN / MAXIMAL OXYGEN UpTAKE (VO2MAX)
1 = VERY pOOR - 7 = EXCELLENT

AGE

1

2

3

4

5

6

7

18-19 <33 33-38 39-44 45-51 52-57 58-63 >63
20-24 <32 32-37 38-43 44-50 51-56 57-62 >62
25-29 <31 31-35 36-42 43-48 49-53 54-59 >59
30-34 <29 29-34 35-40 41-45 46-51 52-56 >56
35-39 <28 28-32 33-38 39-43 44-48 49-54 >54
40-44 <26 26-31 32-35 36-41 42-46 47-51 >51
45-49 <25 25-29 30-34 35-39 40-43 44-48 >48
50-54 <24 24-27 28-32 33-36 37-41 42-46 >46
55-59 <22 22-26 27-30 31-34 35-39 40-43 >43
60-65 <21 21-24 25-28 29-32 33-36 37-40 >40

WOMEN / MAXIMAL OXYGEN UpTAKE (VO2MAX)
1 = VERY pOOR - 7 = EXCELLENT

AGE

1

2

3

4

5

6

7

18-19 <28 28-32 33-37 38-42 43-47 48-52 >52
20-24 <27 27-31 32-36 37-41 42-46 47-51 >51
25-29 <26 26-30 31-35 36-40 41-44 45-49 >49
30-34 <25 25-29 30-33 34-37 38-42 43-46 >46
35-39 <24 24-27 28-31 32-35 36-40 41-44 >44
40-44 <22 22-25 26-29 30-33 34-37 38-41 >41
45-49 <21 21-23 24-27 28-31 32-35 36-38 >38
50-54 <19 19-22 23-25 26-29 30-32 33-36 >36
55-59 <18 18-20 21-23 24-27 28-30 31-33 >33
60-65 <16 16-18 19-21 22-24 25-27 28-30 >30

MAINTENANCE

The equipment requires very little maintenance. Check,

however, from time-to-time that all screws and nuts are

tight.

After exercising, clean the equipment with a soft,

absorbent cloth. Do not use solvents.

Never remove the equipment’s protective casing.

The electromagnetic brake forms a magnetic field that

may damage the mechanism of a watch, or the magnetic

identification strip on a credit or cash card, should they

come into immediate contact with the magnets. Never

attempt to detach or remove the electromagnetic brake!

The electromagnetic brake is based on electromagnetic

resistance; resistance level is electronically measured

and shown as watt reading on the display. Due to the

measurement system, your Tunturi ergometer need not

be re-calibrated when assembled, serviced and used

according to this Owner’s Manual.

MALFUNCTIONS

Despite continuous quality control, defects and

malfunctions caused by individual components may

occur in the equipment. In most cases it’s unnecessary

to take the whole device in for repair, as it’s usually

sufficient to replace the defective part.

If the equipment does not function properly during use,

contact your Tunturi dealer immediately. Always give

the model and serial number of your equipment. Please

state also the nature of the problem, conditions of use

and purchase date.

If you require spare parts, always give the model, serial

number of your equipment and the spare part number

for the part you need. The spare part list is at the back

of this manual. Use only spare parts mentioned in the

spare part list.

TRANSpORT AND STORAGE

Please follow these instructions when carrying and

moving the cycle about, because lifting it incorrectly

may strain your back or risk other accidents:

NOTE!

Always switch the power off and unplug the

power cord before you start moving the equipment

around!

Stand behind the equipment. Grip the seat with one

hand and the handlebar with the other, and set your foot

on the rear support. Tilt the equipment so that it rests

on its transport wheels. Wheel the equipment to move

it, on these transport wheels. Lower the equipment while

holding on to the handlebar and remain behind the

equipment all the time.

NOTE!

Transport the equipment

with caution over uneven surfaces, for example over

a step. The equipment should never be transported

upstairs using the wheels over the steps, instead it must

be carried. We recommend that you use a protective base

when transporting the equipment.

To prevent the equipment malfunctioning, store in a dry

place with as little temperature variation as possible and

protected from dust.

TECHNICAL SpECIFICATIONS

Length .................................................95 cm

Width ...................................................62 cm

Height ..................................................135 cm

Weight .................................................38 kg
This product meets the requirements of the EU’s EMC

Directives on electromagnetic compatibility (89/336/

EEC) and electrical equipment designed for use within

certain voltage limits (73/23/EEC). This product

therefore carries the CE label.

This product meets EN precision and safety standards

(Class HA, EN-957, parts 1 and 5).

Due to our continuous policy of product development,

Tunturi reserves the right to change specifications

without notice.

NOTE!

The instructions must be followed carefully in

the assembly, use and maintenance of your equipment.

The warranty does not cover damage due to negligence

of the assembly, adjustment and maintenance

instructions described herein. Changes or modifications

not expressly approved by Tunturi Oy Ltd will void the

user’s authority to operate the equipment!

We wish you many enjoyable trainings with your new

Tunturi training partner!

Advertising
This manual is related to the following products:

E45