Connecting network cable to the ga1120, Back view of the ga1120, Ethernet connection – Toshiba GA-1120 User Manual
Page 22: Connecting network cable to the ga-1120, Back view of the ga-1120
1
1-10
Connecting to the Network
Connecting network cable to the GA-1120
In this section, the back panel of the GA-1120 is illustrated, followed by information
for connecting to the Ethernet board.
Back view of the GA-1120
Ethernet connection
For Ethernet connections, the GA-1120 supports Unshielded Twisted Pair (UTP)
cabling, defined as Category 5 for use with 100BaseT; or as Category 3, Category 4, or
Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs
into the RJ-45 socket on the GA-1120.
N
OTE
:
The 100BaseT type supported by the GA-1120 is 100BaseTX, also known as
Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
“100BaseT” is used to refer to 100BaseTX.
T
O
CONNECT
TO
THE
E
THERNET
BOARD
•
Connect the network cable to the RJ-45 connector on the back of the GA-1120.
You must use a Category 5 unshielded twisted pair cable network cable for 100BaseT.
Not used
RJ-45 Ethernet (10/100Base T)
Illustration TBD