TRENDnet TDM-E400 - Manual (Page 36)

TDM-E400 / TDM-C400 ADSL2+ Modem Router User’s Manual
36
Table 1. Default Settings Summary
Option Default Properties Explanation/Instructions
LAN interfaces — connecting to your network
Ethernet Static IP address: 192.168.1.254
Subnet mask: 255.255.255.0
DHCP server pool of addresses:
192.168.1.3 through 192.168.1.34 The LAN interface connects the device to your Ethernet
network. Typically, you will not need to change the IP
address. See Chapter 4 for instructions.
The DHCP service (see Chapter 8) is enabled for operation
over this interface, with a pool of private IP addresses for
dynamic assignment to your LAN computers. To use this
service, you must set up your computers to accept IP
information dynamically, as described in Quick Start Part 2.
USB Static IP address: 192.168.1.2
Subnet mask: 255.255.255.0 The USB interface can connect to a single USB-enabled
computer with an IP address in the same subnet. See
Chapter 4 for instructions.
WAN interface — connecting to the Internet
ATM VC VPI = 0
VCI = 35 The VPI and VCI values make up a VC (virtual circuit) that
determines the path your data must take to connect over the
phone lines to the ISP. These values must be changed as
directed by your ISP. See Chapter 5 for more information.
PPP interface PPPoE interface
Login: guest
Password: guest The PPP interface determines the method of communication
with your ISP and logging in to their servers. A particular type
of PPP interface – PPP over Ethernet (PPPoE) – is
configured by default, with the ISP login information shown.
See “Configuring PPP Interfaces” on page 61 for instructions
on modifying this information as required by your ISP.
Services
NAT (Network
Address
Translation) NAPT rule enabled Your computers’ private IP addresses (see DHCP above) will
be translated to your public IP address whenever they
access the Internet. See Chapter 4 for a description of the
NAT service.