TANDBERG MXP - Manual (Page 56)

TANDBERG Maestro MXP
56
Streaming
Source*
ƒ Auto: Enables streaming of both local and far end video.
Selection of which site to be streamed is done using voice
switching (the site that speaks is streamed).
ƒ Local: Only the local video will be streamed.
ƒ Remote: Only the far end video will be streamed.
Local and far end audio is always streamed.
Allow Remote
Start
ƒ On: Streaming can be started from external user interfaces like
the Web-browser or Telnet session.
ƒ Off: Streaming can only be started from the Video Conferencing
System User Interface using the remote control, or by using the
Data port. This will prevent activation of streaming using Web
browser or Telnet sessions. See also Password section below
Announcements
ƒ On: The codec will send announcement packets to the network
that it is streaming. This enables a streaming client (e.g. a PC)
to connect to the codec’s streaming session. Used by Cisco
IP/TV.
ƒ Off: No announcement packets will be transmitted.
Video Rate
Defines the Video streaming rate from the system. Range is 16 kbps -
320 kbps. In addition, audio (G.711) streaming rate is 64 kbps, providing
a maximum streaming rate of 384 kbps.
Streaming
Password
Set password so that only participants entering correct password will be
able to view the streaming session. Entering a password will prevent
unauthorized people from accessing the streaming session.
*The streaming source setting is not available when streaming only is supported outside a call.