TOA Electronics EX-16 User Manual
Page 29
4.3.1 Precedure
(1) Turn
on
power
switch on the exchange.
(2) Adjust
the
sound level of the external PA paging and check the power
remote function.
(a) Connect one station.
(b) Press buttons
and
to test the sound level. Adjust the volume
control of the external amplifier.
(3) Complete a speech test with each of the other stations.
(a) Connect the plug for the station to be tested.
(b) Dial the station number. Check the sound level and the speech quality.
(c) Dial
and
. If a howling noise is heard, then the paging or speaker
stations are too close together.
(4) After
the
speech test is completed for all stations, the sound level adjust-
ment for BGM should be done. To begin, the sound level should be set
so that the BGM is heard from all stations when the power switch of the
exchange is turned on. To turn off the BGM, press the
key once.
4.3.2 Adjusting Method
(a) If exchange does not work:
(1) Turn off the power and disconnect all units from the mother board.
(2) Turn on the power and check the DC voltage at the points on the
mother board illustrated below.
27