TANDBERG Telepresence T3 - Manual (Page 16)

PAGE 16/22
119077.01 TELEPRESENCE T3 ROOM INSTALLATION GUIDE 12.08
TANDBERG
Telepresence T3
tip: Wear gloves at all times when handling
the glass plates.
Caution! The glass panels should be
handled by authorized personnel only.
Caution! Glass plates should always be
stored in upright position.
Caution! The weight of the entire glass
plate should never rest on just one corner.
2. Adjust so that the glass profile is flush with the vertical black side profile
(the one closest to the panels). Mount the angle bracket onto the lower
glass profile (drill a hole for the M5 screw in the glass profile). This should
fix the distance between the wall and the glass profile.
3. Measure the distance between the upper and the lower profiles. Adjust the
distance between the profiles to 1972 mm by adjusting the feet.
4. Use screws to attach the angle brackets to the wall. The glass profiles
should now be fixed.
5. Repeat 2–4 and mount the joint brackets until all are mounted.
ROOM INSTALLATION GUIDE
ThE BLUE WALLS
Note! It is paramount that the distance
between the profiles is 7–8 mm (¼”)more
than the glass panel length (height when
mounted). Otherwise you will not be able
to mount the panels.
Tip! You may want to mount the LED
lights before you mount the glass panels.
Although strictly not needed to do so, you
may find it convenient. LED mounting is
described after this section.