TANDBERG Telepresence T3 - Manual (Page 17)

PAGE 17/22
119077.01 TELEPRESENCE T3 ROOM INSTALLATION GUIDE 12.08
TANDBERG
Telepresence T3
ROOM INSTALLATION GUIDE
ThE BLUE WALLS
6. Carefully unpack the glass walls. Wipe the glass clean if needed. Wear
gloves at all times to avoid leaving marks on the panels. Glass plates must
be stored in an upright position.
imPortANt! The weight of the glass plate should never rest on just one
corner.
Note!
The glass plates should be mounted with the matte side inwards (into
the room).
7. Use the enclosed tape and mount it along the top and bottom edges of
the glass panel. There may be tape visible along the bottom edge after the
mounting. Careful alignment of the tape along the bottom edge will mini-
mize this. You may also use a sharp knife and carefully cut and remove the
excess tape after the panels have been mounted.
8. Mount two rubber bumpers on what will be the right edge (when mounted)
of the left glass panel. Take care to position these so that they will become
covered by the profiles holding the panel in position. The rubber bumpers
serve to prevent the glass panels from touching each other.
Placing the glass walls requires a minimum of two persons. Place the glass
walls in the profiles by lifting the glass so that the top of the glass touches
the surface of the top profile. Then slowly sink the glass into the groove of
the bottom profile.
9. Repeat the rubber bumper mounting for the center panel. Put the second
glass in place as close to the first panel as possible.
tip: Wear gloves at all times when handling
the glass plates.
Caution! The glass panels should be
handled by authorized personnel only.
Caution! Glass plates should always be
stored in upright position.
Caution! The weight of the entire glass
plate should never rest on just one corner.