TROY Group EtherWind 802.11b - Manual (Page 10)

EtherWind Connectors, Switches, and LEDs
Test Switch. Press down this switch for less than 5 seconds to print a test page on
the printer. The test page will show the current wireless and network settings of
the EtherWind wireless print server. Press it down for more than 5 seconds to
reset the EtherWind to its factory default parameters. If you hold the test switch
down upon powering up, the print server will power up in Ad-Hoc mode on RF
Channel 11 with the SSID of printer.
Power Connector. Plug the power supply into this connector.
LED status indicators. The green light comes on when the unit is powered on,
then goes out. The yellow light will come on solid when a wireless network link is
established. The green light blinks during wireless network activity.
Parallel Port (DB25). This port is used for connecting to a parallel printer.
Serial Port (DB9). This port is used for connecting a serial printer or other serial
device. Can also be used to access the command line console of the EtherWind for
configuration and diagnostics.
1-2
Test Switch
Serial Port (DB9)
Parallel Port (DB25)
Power Connector
LED Status
Indicators