TROY Group EtherWind 802.11b - Manual (Page 37)

DEC LAT Network
Configuration
Note:
Only TROY EtherWind-N models include DEC LAT support.
The EtherWind wireless print server acts as a node on an Ethernet network that
offers printing services to other devices. The print server comes preconfigured to
run on a LAT network and does not require any additional setup.
Each print server has a default node name of XCD_xxxxxx (where "xxxxxx" are the
last six digits of the Ethernet address of the unit). The port name is P1 for the
EIO, MIO, or first parallel port; S1 for the first serial port, P2 for the second par-
allel port, and S2 for the second serial port.
VMS LAT Host Configuration
Use the VMS editor to create a text file with the necessary configuration commands
to create a LAT application port and then a VMS print queue. For example:
$MCR LATCP
CREATE PORT LTA
xx:/APPLICATION
SET PORT LTA xx:/NODE=nodename/PORT=port
SHOW PORT LTA xx:
EXIT
$SET TERM LTA
xx:/PASSTHRU/PASSALL/-
TAB/NOBROADCAST/PERM
$SET DEVICE/SPOOL LTA
xx:
$INIT/QUEUE/START/ON=LTA xx:/-
PROC=LATSYM queuename
Note:
LTA
xx is the available LAT port to be used
nodename is the node name of the print server
port is the port, e.g. P1, S1, P2, S2 & LN
queuename is any unique name for the print queue.
8-1
8