Print server configuration – TROY Group EtherWind 802.11b User Manual
Page 40
4. Select the desired File server and press
ENTER
.
5. Select the disk where the print service will reside.
6. Press
F10
in response to the message "The service is running but not yet avail-
able to users."
7. Type in the maximum number of jobs and maximum size of job for the queue
at the
Configure Queue
screen. Or press
F10
for unlimited number and
size.
8. If desired choose a default paper format at the
Configure Paper Formats
screen, otherwise press
F10
to select the default settings.
9. If desired enter the authorized user names at the
Access Lists
screen, or press
F10
for the defaults.
10. At the
Add a Destination
screen, select
PCPrint
and press
ENTER
.
11. At the
Destination Attributes
screen, enter the StreetTalk name of the print
server. Press
F10
.
12. At the Output Strings screen, press
F10
to accept the output string values.
13. At the Enable Strings screen, press
F10
to select the defaults.
14. Select
NO
in response to the message "Would you like to add another destina-
tion at this time?"
15. At the Print Queue Status screen, change both values to
Yes
to enable the
print queue to accept and print jobs. Press
F10
.
16. Press
ESCAPE
multiple times to exit the Manage utility.
Print Server Configuration
1. Install the XAdmin software from the CD-ROM provided with the print server.
Note: Use XAdmin, not XAdmin32, when configuring a VINES-only network.
You can use XAdmin32 on a VINES network only if the PC is running TCP/IP
and both the PC and print server have valid IP addresses.
2. Double-click on the XAdmin icon to start the program under Windows.
3. The print server will show up as "XCD_xxxxxx_P1" where "xxxxxxx" is the
last six digits of the Ethernet address.
4. Click on the
Configure
button.
5. Click on the
Banyan
tab.
6. If necessary change the hop count (default hop count is 2).
7. Enter the StreetTalk name of the print server, this must exactly match the
StreetTalk name of the user that was created using the Manage Users utility.
8. Click on the
Services
tab.
9. Select the desired service to be configured, (default is BINARY_P1).
10. Enter the StreetTalk name of the queue created using the Manage Services utility.
11. Click on
OK
, and then
OK
again to save the configuration.
12. Click
OK
and
OK
again to exit XAdmin
9-2