TRENDnet TV-IP100 - Manual (Page 11)

20
6
H
ARDWARE
I
NSTALLATION
This section describes the Hardware installation procedure for the
Internet Camera.
1 Connect an Ethernet cable
Connect an Ethernet cable to the
network cable connector located
on the Internet Camera’s
rear panel, and then attach it to
the network.
10/100 Ethernet
DC 5V
Reset
21
2 Attach the external power supply
Attach the external power
supply to the DC power input
connector located on
Internet Camera’s rear panel,
and then connect it to your local
power supply.
Note:
Confirm power source is supplied
from the LED indicators label
Power on the Internet Camera
Is illuminated.
10/100 Ethernet
DC 5V
Reset