Perreaux Silhouette SXCD - Manual (Page 28)

27
No disc present
Check that a disc is inserted for the SXCD to play.
No volume setting
Make sure that the volume on your preamplifier or integrated
amplifier is set to a suitable level.
Incorrect input
Confirm that the SXCD output is connected to the appropriate
source input of the preamplifier or integrated amplifier.
Loud speakers not connected
Check that your loud speakers are firmly connected via cables
into the binding posts n the rear of the amplifier.
I can hear a
hum coming
through my
loud
speakers
Input sockets and/or output binding posts corroded
Check that RCA sockets and binding posts on the SXCD and
other associated equipment are all free from corrosion.
Interconnect cables damaged
Make sure that the integrity of your interconnect cables is sound
and they are firmly connected to your preamplifier or integrated
amplifier and the SXCD CD player.
SXCD is close to external interference
Check the proximity of your SXCD to any possible source of
EMI and/or RF interference, for example computers, televisions,
amplifiers, speakers, etc. Ideally the SXCD should be placed as
close as possible to your preamplifier or integrated amplifier.
pLINK
functions
don’t work
Cable not plugged in
Ensure the pLINK cable is connected at both ends, to the SXCD
and the controller device.
Connectors wired incorrectly
Check that the pLINK cable is wired correctly to interface with
the controller device.
RC-5 codes
don’t work
Incompatible remote codes
Make sure the remote control supports CD player RC-5 codes.
Weak remote batteries
The remote control’s batteries may need to be replaced, also
check they are inserted correctly.