Perreaux Silhouette SXCD - Manual (Page 8)

7
2 2 2 2 Instant Install
If you are like us, the first thing you will want to do is to play
your favourite piece of music through your new SXCD Compact
Disc Player. The following instructions are written to enable you
to achieve this as quickly as possible. These are not
comprehensive instructions, but are designed to enable you to
play music now!
Note: Please take the time to read the SXCD manual thoroughly
as it incorporates many features, which will enhance its
operation.
Placement
The SXCD is a low power electronic device and best results will
be achieved when placed away from potential interference from
other components and electrical devices, for example AC mains
cords/outlets, transformers, high-power amplifiers, computers,
etc.
Place the SXCD close or near the preamplifier in order to make
as short a connection as possible.
Turn off associated components
This minimises the potential to damage any other components
when connecting your SXCD into the system.
Connect Transport module to Electronics module
Connect the Transport module to the Electronics module by
connecting the 50-way ribbon cable between the header on the
underside of the Transport and the header at the rear of the
Electronics module. Noting polarity of each connector. Refer to
Chapters 3 and 4 for more information about connecting this
cable.
Connect SXCD to preamplifier
Connect the analog output of the SXCD to the input of your
preamplifier. Refer to Chapter 3 for Rear Panel information.
Connect preamplifier to power amplifier
Connect the audio output from the preamplifier to the input of the
power amplifier.