TOA Electronics N-CC2564 - Manual (Page 10)

10
Camera direction
Secure these two holes first.
(Base unit mounting holes)
Open
Ceiling surface
Mounting screws
Mounting screws
Ceiling surface
Camera direction
2. Release the lock on the hinged portion of the base unit, and connect the composite cable and power cable
to the base unit. (For details, please refer to p. 30; "CONNECTIONS.")
Close
8.2. Mounting Procedures
1. Mount the base unit to the ceiling.
First fix two of the base unit mounting holes as shown below.
Since no mounting screws are supplied with the camera, prepare them separately.
Use screws with a nominal diameter of 4 mm and a length of over 25 mm.
Note: When routing cables over the ceiling surface, securely fix all 4 of the base unit mounting holes to the
ceiling.
Open
Hinged portion
3. Push up and lock the hinged portion of the base unit and secure the remaining two mounting holes.