TOA Electronics N-CC2564 - Manual (Page 24)

24
Saddle bracket Footing
Suspension pipe
Camera
orientation
81
40
70
46
[Mounting hole dimensional diagram]
Unit: mm
Upper ceiling
Power cable
Anchor bolt for safety wire
Suspension plate
(to be prepared separately)
Ceiling panel
Saddle bracket
Suspension pipe
C-channel bar
(to be prepared separately)
Safety wire
(supplied with the C-BC511P)
8
6 7
9
Composite cable
5. Attach the suspension pipe (saddle bracket and footing) to the suspension plate.
Note: Ensure that the installed suspension pipe faces in the intended camera orientation.
6. Install the suspension plate behind the ceiling panel.
• When installing in double-constructed ceilings:
Place the suspension plate across two C-channel bars with its hole aligned with the corresponding hole in
the ceiling panel.
• When installing in strong ceiling materials:
Install the suspension plate with its hole aligned with the corresponding hole in the ceiling panel.
7. Attach the supplied safety wire to the anchor bolt for safety wire.
8. Attach the end of the safety wire to the saddle bracket of the suspension pipe.
9. Run the composite cable and power cable extending from the ceiling through the pipe.