TOA Electronics N-CC2564 User Manual
Page 8
8
[ Top view of Camera Unit ]
[ Bottom view of Camera Unit ]
[ Bottom view of Base Unit ]
(12) Safety Wire
Connects to the base unit.
(13) DIP Switch (SW1)
Not used.
(14) DIP Switch (SW2)
Used to perform various settings of the camera.
(Refer to p. 32; DIP Switch Settings.)
(15) DIP Switch (SW2)
Used to perform various settings of the camera.
(Refer to p. 32; DIP Switch Settings.)
(16) COM SW *
(17) COM LED *
(18) COM PORT *
13
12
14
15
16
18
17
* Parts (16)-(18) are for maintenance purposes (firmware update) only. Avoid using these parts in normal use.
19
20
21
(19) READY LED (Green)
Flashes quickly when the camera is in initial
operation mode, and lights continuously while
the camera is operating. This LED also flashes
slowly during firmware rewrite.
(20) BUSY LED (Yellow)
Flashes during communications.
(21) ERROR LED (Red)
Lights when a failure occurs and camera
operation stops. This LED extinguishes when
the camera is automatically restarted.