TOA Electronics N-CC2564 - Manual (Page 12)

12
Mount straight
An
g
led
inst
a
llation
Push up
Screw section inside the base unit
is to be inserted into the oval hole
in the camera unit.
7. Align the positioning marks, then push the camera unit up into the base unit.
Note
When mounting the camera unit to the base unit,
mount it straight till it is attached to the base unit
correctly. Mounting it at an angle may cause
damage to the camera unit. Note
Take care not to pinch the safety wire between the
camera unit and base unit to avoid damage to the
camera.
8. Turn the camera unit clockwise pushing it up to the base unit until it locks into place.