Tyan Computer THUNDER N3600QX - Manual (Page 17)

J38: SAS Fault LED Connector (5Pin x 2)
Signal Pin Pin Signal
SAS_FAULT_L
ED_N0
1 2
SAS_FAULT_L
ED_N1
SAS_FAULT_L
ED_N2
3 4
SAS_FAULT_L
ED_N3
SAS_FAULT_L
ED_N4
5 6
SAS_FAULT_L
ED_N5
KEY PIN 7 8
SAS_FAULT_L
ED_N7
SAS_FAULT_L
ED_N6
9 10 GND
JP3/JP4: OPMA Setting Jumper (2Pin)
Install: TYAN OPMA Card (Default)
Remove: Other OPMA Card
JP8: Clear CMOS
Pin_3 Pin_1
Normal
(Default)
Pin_3 Pin_1
Clear CMOS
You can reset the CMOS settings by
using this jumper if you have forgotten
your system/setup password or need to
clear system BIOS setting.
-
Power off system and disconnect
both power connectors from the
motherboard
- Put jumper cap back to Pin_1 and
Pin_2 (default setting)
- Use jumper cap to close Pin_2 and
Pin_3 for several seconds to Clear
CMOS
Reconnect power & power on system
17