Tyan Computer THUNDER N3600QX - Manual (Page 64)

3.10 Security Menu
The system can be configured so that all users must enter a
password every time the system boots or when BIOS Setup is
entered, using either the Supervisor password or User password.
The Supervisor and User passwords activate two different levels of
password security. If you select password support, you are
prompted for a one to six character password. Type the password
on the keyboard. The password does not appear on the screen
when typed. Make sure you write it down. If you forget it, you must
clear CMOS and reconfigure.
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection [Disabled]
Install or change the
password.
←
→ Select Screen
↑↓ Select Item
+/- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Feature Option Description
Security Settings
Not Installed
Supervisor Password:
Installed
If the password has been set,
Installed displays. If no password
is set, Not Installed displays.
Not Installed
User Password:
Installed
If the password has been set,
Installed displays. If no password
is set, Not Installed displays.
Change Supervisor
Password
__
Selects this option to change or
install Supervisor Password.
Change User Password __
Selects this option to change or
install User Password.
Disabled
Boot Sector Virus Protection
Enabled
When it is set to [Enabled], BIOS
will issue a virus warning
message and beep if a write to
the boot sector or the partition
table of the HDD is attempted.
64