Topcom BUTLER Quattro - Manual (Page 14)

14 Topcom Butler 3450/Twin/Triple/Quattro
Topcom Butler 3450/Twin/Triple/Quattro
You only need to subscribe the handset if:
•
The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• You want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Topcom Butler 34xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly
for one minute. During this minute, the base unit is in register mode and you must do the
following to subscribe the handset:
•
Press and hold the key for 3 sec, then press and hold the * key for 3 sec.
• The following will appear on the display:
• Enter the number of the base unit you would like to subscribe the handset to (1-4)
• The unit will start searching for the base and when found it will ask to enter the pin code
(4 digits):
• Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching
for the base.
• When the handset is registered, it will show ‘HS’ followed by the handset number.
7.2 Subscribing a TOPCOM Butler 300 DECT GAP Headset
Press the Paging key on the base unit for 10 seconds until the Line/charge indicator on the
base unit starts to blink quickly. The line/charge indicator will blink quickly for one minute.
During this minute, the base unit is in subscribing mode and you must do the following to
subscribe the headset:
• Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At
the same time the red and green LED will lit ones.
• Remove the rubber cover of the power socket so that the hole of the power socket is
free. Pull out the rubber cover from the headset so that the registration key hole is free
also.
• Press the headset registration key. The red LED will flash rapidly.
– If after a few seconds the green LED flashes slowly, the registration is successful.
– If the red LED flashes slowly, the registration is failed. Repeat above procedure.