Thermador P24WK - Manual (Page 10)

Step 3: Unpacking, Moving, Placing
and Anchoring the Cooktop
1. Remove the outer carton and packing material
from the shipping base. Ensure that you have
all cooktop components before proceeding.
2. Remove the top grate castings, burner caps
and grill grate (if so equipped) to reduce unit
weight.
3. Lift and place the cooktop in the opening. Be
careful not to pinch the power cord or gas inlet.
Care should be taken not to scratch the griddle
or the griddle frame.
IMPORTANT
• Verify that the appliance is correct for
the type of gas being provided. Refer to
Step 4 before proceeding with the instal-
lation.
• Attach the backguard before sliding the
appliance into the final installed posi-
tion. See Step 6.
CAUTION
Proper equipment and adequate manpower
must be used in moving the appliance to
avoid damage and/or personal injury. The
unit is heavy and should be handled accord-
ingly.
4. Ensure that the power line cord is free and
hanging loose.
5. Level the appliance. For proper performance,
the appliance must be level.
6. The grill frame (if so equipped) has been leveled
during assembly so do not attempt to level the
grill.
7. Replace the top grate castings, burner caps
and grill grate (if so equipped). Ensure that the
burner caps are correctly seated on the burner
bases.
8
Griddle Tilt Adjustment
Check the griddle frame adjustment by pouring two tablespoons of water on the back of the
griddle plate. The water should slowly roll into the grease tray. If not, adjust the two screws
under the back of the griddle frame. Start with one half turn CCW of the screws. Further
adjustment should be made by one-quarter turn until water slowly flows into the grease tray.