Thermador P24WK - Manual (Page 3)

The Thermador Professional ® Cooktops are available
in a number of sizes and configurations. Model P24WK
is a 24"-wide wok unit featuring a power burner rated
at 30,000 BTU/HR. The 30"-wide Model PC304 fea-
tures a gas cooking surface with four sealed burners.
The 36"-wide Models PC364GE, PC364GL, and
PC366 feature four sealed burners and an electric
griddle, four sealed burners and a gas grill, or six
sealed burners, respectively. The 48"-wide Models
PC484GGE, PC486GE, PC486GL and PC484WK
feature four sealed burners, electric griddle and gas
grill, six sealed burners and an electric griddle, six
sealed burners and a gas grill, or four sealed burners
and a 30,000 BTU/HR WOK, respectively. All sealed
Introduction
GAS SUPPLY:
Natural Gas – 6 inch water column.
Propane Gas – 11 inch water column.
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING
IMPORTANT: LOCAL CODES VARY. INSTALLATION, ELECTRICAL CONNECTIONS,
GAS CONNECTIONS, AND GROUNDING MUST COMPLY WITH ALL APPLICABLE CODES.
Model PC364GD
(Shown with Low Back Model GPS36LB)
Model P24WK
(Shown with Low Back Model GP24LB)
1
WARNING
Disconnect power before installing. Before
turning power ON, be sure that all controls are
in the OFF position.
ELECTRICAL POWER SUPPLY:
36" Models:
PC366- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
PC364GL- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
PC364GE (with electric griddle)- 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit.
30'' models:
PC304- 120 VAC, 60 Hz., Ph., 10 Amp circuit
48" Models:
PC486GL- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
PC486GE- 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit.
PC486GGE (with electric griddle) - 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit.
PC484WK- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
24" Model
P24WK- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
IMPORTANT: Save these instructions for the Local Electrical Inspector’s use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.
burners are rated at 15,000 BTU/HR, electric griddles at
1,600 watts, and grills at 18,000 BTU/HR.
IMPORTANT
• A backguard must be utilized when there is less than
a 12" horizontal clearance between combustible
materials and the back edge of the cooktop. The
Thermador Low Back backguard must be ordered
separately and installed at the rear of the cooktop.
For island installations and other installations with
more than 12" clearance, an optional stainless steel
Island Trim is available to cover the backguard
mounting flanges.
• Verify that the appliance is correct for the type of gas
being provided. Refer to Step 4 before proceeding
with the installation.