TacT Audio S2150 - Manual (Page 17)

17 Tact Audio
1 - STANDBY
The STANDBY button will turn the M/S 2150 “ON” or it will place it into “STANDBY”
mode. When in standby mode, the unit is placed into a low power “idiling” state.
The standby button is also used to save changes that were made in the menu
editing parameters. By placing the unit into standby the current settings are
saved.
2 - DIGITAL
The DIGITAL button will scroll sequentially, allowing the selection of one of the 5
digital inputs.
3 - ANALOG
The ANALOG button will scroll sequentially, allowing the selection of one of the 3
analog inputs.
4 - CORRECTION block
The CORRECTION block buttons are inactive with this unit.
5 - MENU
The MENU button will switch the front panel display from the status screen to the
main menu screen.
6. VIDEO
The VIDEO button is inactive with this unit.
7. UP
The UP navigational button is used to select menu options and/or change their
values.
8. DOWN
The DOWN navigational button is used to select menu options and/or change their
values.
9. LEFT
The LEFT navigational button is used to select menu options and/or change their
values.
10. RIGHT
The RIGHT navigational button is used to select menu options and/or change their
values.
11. ENTER
The ENTER button will select the menu option currently marked by the blinking
cursor or is used to enter an edited parameter.
12. VOLUME Block
The VOLUME block consists of three buttons.
The “MUTE” button will mute/un-mute all enabled channels.
The “UP” button will increase the master volume level
The “DOWN” button will decrease the master volume level.
Remote Control