TacT Audio S2150 - Manual (Page 24)

CAUTION CAUTION
24 Tact Audio
COMM menu
(Communication)
REM menu
(Remote)
The remote menu allows for disabling or enabling the remote control. Once the re-
mote control is disabled the unit can only be controlled from the front panel of the
unit. An alternate way to enable or disable the remote control is to press the front
panel “ANALOG” and “DIGITAL” button simultaneously - this can be used to
change the remote control state without entering the REM menu.
The communication menu allows for RS232 baud rate selection. By default the
2150 amplifier is set to a baud rate of 57600. However, some remote control sys-
tems may require a baud rate of 9600. The menu also contains the option to set
the M2150 as a master controller for a system with multiple 2150 amplifiers.
REMOTE CONTROL: ON
OFF ON
1 - Remote control settings.
2 - Active remote control setting.
Remote Menu :
Use the “LEFT” and “RIGHT” buttons to highlight the desired option and select it
with the “ENTER” button.
BAUD RATE: 57600
57600 9600 NORMAL
1 - 57600 baud rate setting.
2 - 9600 baud rate setting.
3 - Active baud rate setting.
4 - Master/Normal control setting. (M2150 ONLY)
Communication Menu :
NOTE: MASTER control is only available on the M2150.
1 4 2
3
2
1
Front Panel Display
Use the “LEFT” and “RIGHT” buttons to highlight the desired option and select it
with the “ENTER” button.