TacT Audio S2150 - Manual (Page 22)

CAUTION CAUTION
22 Tact Audio
- Max Level controls the system’s maximum signal level.
For example: if this option is set to -3.0 dB, the volume control
and output can not go above -3.0 dB.
- Detection sets the signal detection threshold. If the absolute
value of the Left or the Right channel signal goes above this
threshold the red signaling dot will be displayed on the front
panel bellow the master volume display. This feature can be used
to indicate signal presence on either channel or to indicate near
clipping condition. To use it as signal presence indicator set Detec-
tion to a value close to -90.0 dB. To use it as near clipping indicator
set Detection to a value close to 0.0 dB.
- Wheel option sets the wheel sensitivity. The maximum speed is 10 and
minimum speed is 1. For example if the speed is set to 1, the volume increase is
slower than if set to 10. To turn the wheel off, set the speed setting to “OFF”.
This setting is located one step below “1” the minimum speed.
OPT menu
(Options)
The options menu is designed to control the systems maximum signal level
“MAXLEV”, signal detection threshold “DTHR” and wheel speed “WH”.
MAXLEV DTHR WH
+12.0 -6.0 dB 5
Options Menu :
1 - Maximum Level setting.
2 - Detection setting.
3 - Wheel speed setting.
1 3 2
To select/highlight an option use the “LEFT” or “RIGHT” buttons. To modify a se-
lected option use the “UP” and “DOWN” buttons.
NOTE: Wheel speed is only available on the M2150.
Front Panel Display