Unified Brands HYPERSTEAM HY-6G(CE) - Manual (Page 10)

10 OM/SM-HY-6G(CE)
OM/SM-HY-6G(CE)
10
5.0 - Operation
WARNING
ANY POTENTIAL USER OF THE EQUIPMENT SHOULD BE TRAINED IN SAFE AND CORRECT OPERATING
PROCEDURES.
5.1 Controls
Operator controls are on the front right of the unit.
The control panel has the following touch pads and
indicator lights. (Your controls may have either words or
the symbols shown below):
The ON/OFF touch pad gets the
HyPerSteam ready for use, or shuts it off.
The READY indicator light shows that the
steam generator is at standby
temperature and the cavity is hot enough
to begin steaming.
The CLEANING indicator lights when the
unit is operating in the cleaning mode.
The SERVICE indicator light shows when
the water level probes have stopped
working, and need to be cleaned
(normally an indication of lime deposits).
When one probe is not working, the
SERVICE light flashes briefly every few
seconds. When both probes fail, the light
will flash continuously and the beeper will
sound.
The HI TEMP indicator light comes on
when the steam generator is too hot.
The unit will automatically shut off, and
cannot be turned on again until it has
been serviced.
The TIMING indicator light stays on when
the timer is running.
The CLEAN touch pad is used to start the
automatic 50 minute cleaning cycle.
The timer is used in three ways:
1 In the OFF position the steam generator stays at a
low boil or “holding” temperature.
2 When a cook time is set, the unit steams until the
timer reaches OFF. The steaming stops, a red light
comes on and a beeper sounds.
3 With the timer turned to the ON position, the unit
steams continuously. The green light stays lit. The
steamer will not time down.
Gas Lockout Indicator and Reset Control
Should the pilot fail to ignite during start-up, a yellow
indicator on the control panel (see page 11) will light
and the supply of gas to the unit will be halted.
When this occurs, the ignition process may not be
started again for five minutes. After that time, press the
Lockout Reset Switch located behind the front panel
and attempt to start the unit again. If the lockout
continues to occur after three attempts, contact your
Groen Service Agency for assistance.
5.2 Operating Procedure
5.2.1
Press the ON/OFF touch pad for the steamer.
The steam generator will fill, and heat until the
READY light comes on. (About 10 minutes.)
5.2.2 Load food into pans in uniform layers. Pans
should be filled to about the same levels, and
be even on top. The maximum allowable weight
of food is 9.8 kilograms (21.6 lbs.) per pan.
5.2.3 Open the door and slide the pans onto the
supports. If you will only be steaming one pan,
put it in the middle position.
5.2.4 Close the door. With the READY indicator lit,
take one of the following steps:
• If you want to steam the food for a certain
length of time, set the timer for that period. The
timer will automatically run the steamer for the
set time and then turn it off. A red light will
come on and a beeper will sound. Steam
production stops.
• To steam continuously, turn the timer to the
manual ON position. A green light will come
on. The unit will continue steaming until you
stop it by turning the timer to OFF. When
steaming continuously YOU MUST CONTROL
STEAMING TIME.
WARNING
WHEN YOU OPEN THE DOOR, STAY AWAY FROM
THE STEAM COMING OUT OF THE UNIT. THE
STEAM CAN CAUSE BURNS.
5.2.5 Open the door. Remove the pans from the
steamer, using hot pads or oven mitts to protect
your hands from the hot pans.
5.2.6 To shut down the unit, press the ON/OFF touch
pad OFF. The steam generator will drain.