Unified Brands HYPERSTEAM HY-6G(CE) - Manual (Page 12)

1 OM/SM-HY-6G(CE)
OM/SM-HY-6G(CE)
12
6.0 - Cleaning
To keep your HY-6E Steamer in proper working condition/order, use the following procedure to clean the unit.
This regular cleaning will reduce the effort required to clean the steam generators and cavities.
6.1 Suggested Tools
1. Mild detergent
2. Stainless steel exterior cleaner such as Zepper®
3. Steam generator de-liming agent, such as
Groen Delimer Descaler, Lime-Away® or an
equivalent. A liquid de-liming agent will be
easier to use than crystals or powders. See the
warning about chlorides, below
4. De-greaser, such as EncompasS®, Malone 34®,
Puritan Puribrute®, or Con-Lie®
5. Cloth or sponge
6. Plastic wool or a brush with soft bristles
7. Spray bottle
8. Measuring cup
9. Nylon pad
10. Towels
11. Plastic disposable gloves
12. Funnel
6.2 Procedure
6.2.1 Outside of Steamer
1. Prepare a warm solution of the mild
detergent as instructed by the supplier. Wet
a cloth with this solution and wring it out. Use
the moist cloth to clean the outside of the unit.
Do not allow freely running liquid to touch the
controls, the control panel, any electrical part, or
any open louver.
2. To remove material which may be stuck to
the unit, use plastic wool, a fiber brush, or a
plastic or rubber scraper with a detergent
solution.
3. Stainless steel surfaces may be polished
with a recognized stainless steel cleaner such as
Zepper®.
WARNING
DISCONNECT THE POWER SUPPLY
BEFORE CLEANING THE OUTSIDE OF
THE STEAMER.
KEEP WATER AND CLEANING
SOLUTIONS OUT OF CONTROLS AND
ELECTRICAL COMPONENTS. NEVER
HOSE OR STEAM CLEAN ANY PART OF
THE UNIT.
DON’T MIX DE-LIMING AGENTS (ACID)
WITH DE-GREASERS (ALKALI)
ANYWHERE IN THE UNIT
AVOID CONTACT WITH ANY
CLEANERS, DE-LIMING AGENT OR DE-
GREASER AS RECOMMENDED BY THE
SUPPLIER. MANY ARE HARMFUL.
READ THE WARNINGS AND FOLLOW
THE DIRECTIONS!
EVEN WHEN THE UNIT HAS BEEN SHUT
OFF, DON’T PUT HANDS OR TOOLS
INTO THE COOKING CHAMBER UNTIL
THE FAN HAS STOPPED TURNING.
DON’T OPERATE THE UNIT UNLESS
THE TWO REMOVABLE INTERIOR
PARTITIONS HAVE BEEN PUT BACK IN
THEIR PROPER LOCATIONS.
DON’T USE ANY CLEANING OR DE-
LIMING AGENT THAT CONTAINS ANY
SULFAMIC AGENT OR ANY CHLORIDE,
INCLUDING HYDROCHLORIC ACID
(HCl). TO CHECK FOR CHLORIDE
CONTENT SEE ANY MATERIAL SAFETY
DATA SHEETS PROVIDED BY THE
CLEANING AGENT MANUFACTURER.
IMPORTANT
DO NOT USE ANY METAL MATERIAL (SUCH AS METAL SPONGES) OR METAL IMPLEMENT (SUCH AS A
SPOON, SCRAPER OR WIRE BRUSH) THAT MIGHT SCRATCH THE SURFACE. SCRATCHES MAKE THE
SURFACE HARD TO CLEAN AND PROVIDE PLACES FOR BACTERIA TO GROW. DO NOT USE STEEL
WOOL, WHICH MAY LEAVE PARTICLES IMBEDDED IN THE SURFACE WHICH COULD EVENTUALLY CAUSE
CORROSION AND PITTING.