Uniden XCA750 - Manual (Page 18)

If the Base Unit loses power while the Handset is off the Base, the Digital
Code may be erased. When this happens, the Handset will not function. To
reestablish communication between the Handset and Base Unit:
1. Restore power to the Base
Unit.
2. Place the Handset back on
the Base Unit.
I!
3. The charge LED will blink
quickly, indicating that the
Digital Code has been reset.
Making and Receiving Calls
The following features of the XCA650/XCA750 phone are different
depending on the Handset’s Location when you make or receive a call.
ANSWER
CALL
HANDSET ON
BASE
Pick up Handset
(AutoTalk)
1) Pick up Handset
MAKE CALL 2 )
3) Listen for dial tone
4) Dial the number
Press
HANG
U P
Return Handset to Base
(AutoStandby)
OFF
Press button on the
Base Unit.
You must use the
Handset to make a call.
Press speaker button on the
Base Unit.
REDIAL
1) Pickup Handset
2) Press
3) Listen for dial tone
4) P r e s s
You must use the
Handset to make a call.
Note: Sometimes when you press to hang up the phone, you may get
an error tone and the phone will not disconnect. If this happens,
place the Handset on the Base Unit or press again while
holding the Handset close to the Base Unit.
Using Your Phone
29
30