Uniden XCA750 - Manual (Page 19)

Changing Channels, Flash, and Page/Find Programming Your Phone
To change channels or access call waiting while the phone is in use, or to
use the one-way page to locate the Handset, follow these steps:
HANDSET BASE UNIT
CHANGING
CHANNELS
FLASH
Press
Note: Change channels to
help eliminate background
noise.
If the call waiting tone
sounds, press accept
the waiting call.
If you have finished a call
and want to make another
call, press to hang up
and aet a dial tone.
Note: You must use the
Handset to change
channels.
Note: The Base Unit does
not have You must use
the Handset for call waiting
and to make a call.
PAGE/FIND
Note: When page/find is Press page/find on the
pressed on the Base Unit, Base Unit to locate the
the Handset beeps. Handset.
Note: If you do not have any special phone service, pressing FLASH might 1. Remove the Handset from
disconnect the current call. the Base Unit.
If the above FLASH operation does not work and you have the “Easy
Call” service connected then follow your service provider’s instruction to
operate “Call waiting’:
2. Press
The talk/batt low LED blinks.
For convenience, the Handset has ten memory locations so you can store
the numbers you use most often in either place. Just remember that all
programming functions must be completed when your phone is in the
standby mode, since the programming keys do not function while you are on
the phone.
Storing a Number in Memory
Use these keys
to store a
number in
memory with the
Handset.
Note: An error
tone will sound
and the
programming
procedure will be
canceled if more
than 20 seconds
elapse between
each keystroke
entry or step.
31 32