Univex ProSafe WFS709TP User Manual
Page 16
WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide
1-4
Introduction
v1.0, May 2007
Port LNK/ACT LEDs. Each FE port has its own LNK/ACT LED on the upper-left side of the
port. During operation, these LEDs provide the following Ethernet link status information:
Port PoE LEDs. Each FE port has its own PoE LED on the upper-right side of the port. This
LED provides the following PoE status information:
ACCESS POINT STATUS LEDs. Each FE port has an identically numbered Access Point
Status LED that represents the status of APs connected to that port on the WFS709TP ProSafe
Smart Wireless Switch. During operation, the LEDs provide the following AP status information:
Status
Description
Off
No Ethernet link on the port.
Green
An Ethernet link has been established on the port, but no data is currently being
transmitted or received.
Flashing Green
The port is transmitting or receiving data. The flashing rate is proportional to the
network activity.
Amber
The Ethernet link on the port is encountering errors.
Status
Description
Off
The port is disabled, or the attached device has not requested power. PoE is not being
provided by the port.
Green
PoE is being provided to the attached device.
Amber
The attached device has requested power, but POE is not being provided by the port.
Status
Description
Red (solid)
An AP on this port has failed (highest precedence).
Red (flashing)
An air monitor on this port has detected an unsecured AP. The AP is attached to your
network but is not listed in the security policies. If security policies are enabled, clients
are not granted access to your network through the unsecured AP.
Green (flashing)
An air monitor on this port has detected interference. The interfering device (AP or
other radio source) has been detected by your valid APs, but has no wired presence
on your network.
Amber (solid)
Load balancing is enabled on this port, or an AP has reached the maximum number of
clients it is configured to support.
Green (solid)
All detected APs on this port are operating as expected.
Off
No AP is detected on the port (lowest precedence).