Ge uplink port, Serial console port, Ge uplink port -5 – Univex ProSafe WFS709TP User Manual
Page 17: Serial console port -5
WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide
Introduction
1-5
v1.0, May 2007
The LED states are listed in order of precedence (highest to lowest). If more than one AP is
connected to the port, the state with the highest precedence is displayed.
GE Uplink Port
The WFS709TP ProSafe Smart Wireless Switch provides one Gigabit Ethernet (GE) 10/100/1000
Mbps 1000BASE-T copper port for high-bandwidth connection between the switch and the wired
LAN. The port automatically senses and negotiates speed, duplex, and MDI/MDX settings.
Figure 1-3 shows the following callouts:
•
Gigabit Ethernet port
•
LNK/ACT LED, which provides the following information:
for cable specifications.
Serial Console Port
Use this port to connect a local management console. This connection can be used to access the
text-based command-line interface (CLI) for initial configuration of the WFS709TP.
Status
Description
Off
No Ethernet link on the port.
Green
An Ethernet link has been established on the port, but no data is currently being
transmitted or received.
Flashing Green
The port is transmitting or receiving data. The flashing rate is proportional to your
network activity.
Figure 1-3
Note: The Gigabit interface is not user-replaceable. Do not remove the port cover plate.
3
1
2
4