Uniden BCD996T - Manual (Page 110)

110
Setting the Delay Time
[MENU] Srch/CloCall Opt F
Set Delay Time F
This setting determines how long the scanner waits after a transmission ends
before resuming Quick Search or Close Call operation.
1-5 sec — The scanner waits the set amount of time after the transmission ends
before resuming. The default setting is 2 sec.
Off — The scanner resumes immediately when the transmission ends.
Setting the Search Frequency Step
[MENU] Srch/CloCall Opt F
Set Step F
This setting lets you select the frequency step used during Quick Search and
Close Call.
Auto — The step is based on the band (see the table at the front of the manual).
This is also the default setting.
Setting Record
You can set the REC jack to provide an audio signal to a sound recording device
(tape, PC, flash memory) for live recording of transmissions. This also lets you
record Quick Search and Close Call transmissions.
[MENU] Srch/CloCall Opt F
Set Record F
On — enables an output to an audio recorder at the REC (record output) jack.
Off — disables an audio signal at the output jack.
5.0 kHz, 6.25kHz,
7.5 kHz,8.33kHz,
10.0 kHz, 12.5 kHz,
15.0 kHz, 20.0 kHz,
25.0 kHz, 50.0 kHz,
100.0 kHz
The scanner uses the selected step.