Uniden BCD996T - Manual (Page 96)

96
Set Delay Time — lets you set the amount of time the scanner will delay before
continuing to search after a transmission ends.
Set Modulation — lets you set the custom search range’s modulation type.
Set Attenuator — lets you set whether the scanner will attenuate reception by
20 dB during search.
Set Data Skip — lets you set whether the scanner will skip data transmissions
during search.
Set Step — lets you set the custom search range’s step (the gap between
frequencies).
Set C-Ch Only — lets you search for a Motorola control channel. If it finds one,
the scanner scans the system.
Set Record — if during your listening to the selected service, if a transmission is
received, choosing On will send an audio signal to the connected audio recording
device.
Adjust P25 Level — adjusts the digital decode threshold to match the
transmission you are hearing when it receives a strong signal and has a high
decode rate.
Search with Scan — sets whether the scanner includes the custom search
during scanning. If unlocked, the scanner first scans all selected systems, then
searches the selected service searches for the selected hold time (0-255
seconds).
Within this menu item are the following settable options
Set Quick Key — lets you assign a Quick Key for the custom search range.
Set Startup Key — lets you decide which custom search range should be
unlocked and scanned at power up
Set Lockout — lets you lock the custom search range for this session or
permanently as with any other L/O action.
Set Hold Time — sets how long (seconds) the custom search range is checked
before the scanner moves to the next programmed entry.
Search With Scan
When you press [SCAN/SEARCH] the BCD996T starts a scan of those sites,
channels, etc you have manually programmed or the Uniden preprogrammed data